Approximately 800 miles of electrical
conduit in 10-foot sections have been laboriously painted, first with
smelly, toxic weird purple stuff and then with glue at the ends,
jammed together until the glue set and dropped into the
three-foot-deep trench, all while carefully running a 400-foot long
string through them and keeping it untangled and Not letting it get
glued into the joints. Much. We did have to cut off one pipe section
and redo it, but what's one out of 40-odd?
Also, while not falling into said
trench, or purpling or gluing ourselves, or any of the other possible
mishaps that could have occurred. Except for that one unfortunate
time I dropped the pipe the several feet down into the trench and the
curved fiberglass elbow at the other end of it slammed very painfully
into DH's ribs.
Oopsie.
Sorry about that. I thought he Said we
were supposed to drop the pipe into the trench. Apparently not. He
did say some other words, though, after I dropped it...
At any rate, we also glued the bendy
elbows onto the ends of the conduit, and ran another 50-foot line of
larger conduit from the transformer site to the house, and tied the
official pull string required by the power company onto the original
string and pulled it through, and covered the conduit with soil, and
DH is now building a gravel pad for the transformer to sit on.
All of which left us as out of breath
as you are after reading that last sentence.
At one point, as we sat on the edge of
the trench panting for breath and contemplating our various aches, DH
said, “Isn't this fun? I told you building a house would be fun.”
I didn't have enough breath to laugh.
Keeping the 400-foot long string
straight was no end of fun, as it tangled on every single grass and
weed stem in its path, and, when it couldn't find anything else to
grab, just tied itself into complex knots.
The sequence went like this: We would
pick up a 10-foot pipe section, look through it to make sure it was
relatively clean, then stuff a long piece of thin plastic pipe, tied
to the string, through it, with a rag wadded on the end to clean out
dust and cobwebs. We were also making sure that the bell end of the
new pipe was facing the narrow end of the other pipe. Then we would
hold the new pipe next to the already-glued segment of pipe, and hold
onto the string, and DH would paint both near ends purple, then paint
them with glue, then I would run to the end of the new pipe to pull
the string tight while we both jammed the bell end onto the narrow
end and pushed and twisted until they were tightly connected, and
held them a few seconds until the glue set, which it did really fast,
so there wasn't a lot of time for dilly-dallying. Ten-foot lengths of
plastic pipe – er, conduit – get heavy after awhile, and some of
this was done from very un-ergonomic positions, owing to the mounds
of dirt piled around the trench. My arms got sore and some of DH
ended up a little purple.
But the conduit has now been inspected
and approved by the power company, so, progress! However, we cannot
have power until we have put the water lines into the trench and
covered them up so that all the ground is level again. Then the power
company will fasten the high-voltage actual power lines to the pull
string, pull it through the conduit and install a transformer on the
gravel pad by the house.
Getting the water lines in will entail
“welding” about 300 feet feet of polypropylene pipe together in
20-foot sections and dropping placing them carefully
in the trench, running from the well to the house. You can't, of
course, actually weld plastic pipe; instead, you take some special,
expensive tool that gets ridiculously hot and melt the ends of the
pipe sections and then jam them together so they stick and become
one.
Preferably without welding oneself. I
dislike these projects that require dangerous cutting or heating
implements, but I guess that's why DH is the one who got certified to
do the welding.
But first, he's re-digging out the
parts of the trench that we accidentally back-filled too much, to get
it back down to the correct two-foot depth.
Stay tuned for further adventures ...